| CODE SYMBOL | MEANING | SOLUTION |
|---|---|---|
| Hot LED Flashes | Lid is open when washer is running. | Close the lid tightly and restart the cycle. If the code reappears, call for service. |
| Warm LED Flashes | Communication error between SUB PBA and MAIN PBA. | Call for service. |
| Cold LED Flashes | A button is not working properly. | |
| Tap Cold LED Flashes | The Water Level sensor is not working properly. !!! When the Tap Cold LED is flashing, the washer drains for 3 minutes. During this time, the Power button is inoperative. | |
| Extra Large LED Flashes | Your Washer has tried to fill but was unsuccessful. !!! When the Extra Large LED is flashing, the washer drains for 3 minutes. During this time, the Power button is inoperative. | Make sure the water faucets are open all the way. Check for kinked hoses. Check the inlet screens on the fill hoses. If you use a Flood Safety Device, remove the device and connect the water hoses directly to the unit. |
| Check if the hot water supply hose is connected. | You must connect the hot water supply hose because hot water is supplied by the Auto Temperature Control (A.T.C.) function. | |
| Large LED Flashes | Your Washer has tried to fill but has not reached the proper water level. !!! When the Large LED is flashing, the washer drains for 3 minutes. During this time, the Power button is inoperative. | Call for service. |
| Medium LED Flashes | A fault is detected in the water level sensor. | v |
| Small LED Flashes | Your washer is not draining. It can also mean that the unit senses a small clog while draining. | Do the following: 1) Turn off the unit and turn it on again. 2) Select only the Spin Cycle. 3) Press the Start/Pause to drain the water. If it still does not drain, call for service. |
| Hot & Warm LEDs flash | Unbalanced load prevented your Washer from spinning. | Redistribute the load, and then press the Start/ Pause button. |
| Hot & Cold LEDs flash | Motor not running properly. | Restart the cycle by presssing the Start/Pause button. If the code reappears, call for service. |
| Hot & Tap Cold LEDs flash | Mems sensor is not working properly | Call for service. |
| Hot & Extra Large LEDs flash | Door lock is not working properly | Close the lid tightly and restart the cycle. If the code reappears, call for service. |
| Hot & Large LEDs flash | Door lock is not working properly. | |
| Hot & Medium LEDs flash | Thermistor is not working properly. | Call for service. |
| Hot & Small LEDs flash | The temperature of the supplied water is so high. | Ensure that the cold water tap and the hot water tap are connected correctly. If the code reappears, call for service. |